Eagleville, PA

Fully assessed no cooling situation on trane inverter system installed 8/12/25 by dibiase. Found inverter would start in cooling mode and then after a few minutes it would switch to heating mode. Jumped out wiring at ecobee thermostat and found it still was doing the same thing. Went up to air handler and found o wire was very loose in wire nut and not making a good connection. Re did wiring connection . Checked at outdoor unit and found it now keeping 27 v between c&o. System is now staying in cooling mode. Also went through installer settings and found lock out on heat pump set to 35 degrees. Changed it to 0. Heat pump is working properly at time of service.

Sealed air leaks on supply Plenum and wrapped one supply run also added ecobee sensor check switch settings and tested system. Charge is up to standards and system is running to manufacturer specifications.

Installed new Trane air handler in a new auxiliary drain pan.installed a new Aprileair filter box on the return. Adapted to supply and return ductwork. Re wrap supply duct work and return box with new insulation. Installed a new eztrap and wet switch for the condensation drain. Installed a new 240v switch. Installed a new ecobee light thermostat with a new 18/8 wire. Installed new breaker for the air handler in the sub panel. Installed new Trane heat pump on a new concrete pad and new heat pump legs. Installed new tan line hide and ran new refrigeration line set from outdoor unit to indoor unit. Brazed all connections and pressure tested to 350psi and leak checked all connections before evacuating system down below 500 microns. Installed a new rectorseal disconnect with built in surge protector.

Est

Estimate

Office booked. No site visit

Arrived for water leak on an AC system. This is a landlord tenant situation. Customer has a walk up attic to the indoor air handler. I checked the indoor unit. Customer replaced two air filters 14 x 14x1 . I checked my blower static had 1.1 static is high probably due to small returns. I used my charging jacket to get the pressures up. Head pressure. Got 265 head pressure, my suction stayed the same at 100 psi found indoor TXv was frosting up. Indoor TXv is failing. I quoted the cost for two prices one for non-warranty one for warranty he will get back to us and give us a call on Monday. I collected for my time here today.

Customer stated that the master bedroom exhaust fan was not working properly check fan operation. Upon arrival check suction on the fan went up to the attic and noticed that there was two hard bends at the 4 inch duct. Also cut back about 4 feet and made it so only has one bend check performance after adjustment ok suction on fan increase. No charge warranty

Perform precision heat tuneup on 1995 train 80% gas furnace. Checked all electrical connections and components. Tested blower capacitor check resistance of hot surface igniter. Cleaned flame sensor. Replaced 20 x 25 x 1“ air filter. Found old and accurate T 87 mercury thermostat. Provided estimate for Honeywell T4 thermostat. Examined heat exchanger with camera. Furnace is getting pretty old and should consider replacement. Performed Combustion test. Gas furnace is working at time of service.

Air sealed and insulated basement rim joist and sill plate. Vented 2 bathroom exhaust fans to gable vents in attic. Sealed 2 lowered ceiling areas in attic space with air barrier material and 1 part foam.